中国·永利y23455(股份)有限公司

-       The dynamic pulling test

-       Requires wind gusts at least 25 km/h

-       Uses real wind instead of cable

-       As the tree is measured in real windy situation, the effect of the surroundings, the actual crown and soil conditions are included

The DynaRoot system should be used on days with at least 25 km/h (15 mph) wind gust velocities. Setting up the measurement involves the following steps.

1. Assemble the anemometer tower in the vicinity of the     tree(s) to be assessed. Attach the anemometer on the top, and erect the     tower. Wind velocity readings are sent to, and data is collected at the     instrument box located at the bottom of the tower.

2. Start recording data by pressing the START button     located in the instrument box.

3. Mount the inclinometer on the root collar of the     tree to be assessed.

4. Start recording data by pressing the START button     located on the side of the instrument box.

5. Repeat the previous 2 steps if you have more     inclinometers and want to assess multiple trees.

6. Record data for at least 3 hours (the longer the     better).

7. After the recordings are finished, transfer the     acquired data to a PC by removing the internal SD card or by switching the     instruments to Wi-Fi mode.

8. Load the data into the DynaRoot evaluation software     and calculate the safety factor.